TK-330 SERIES
Home > Products > > TK-330 SERIES
Automatic rubber compression molding machine
Special Feature
 
1.High productivity – Every station two molds with two-side operation.
2. Easy operation – Auto sliding in/out and inside-turning design for molds.
3. Energy saving – Special insulation design to prevent heat loss.
4. Precise temperature – Every mold with separate temperature control.
5. Flexible setting– Pre-cure, curing, pumping time can be set freely.
 
Mold Carrier Unit
 
1. Every station is with two-side operation; two sets of molds can be adopted on each station to increase productivity. Machine size is compact and utility rate of factory space is higher.
2. Every station is with electric heating control system; mold temperature can be set according to shoe pattern for ensuring most ideal curing.
3. Every station is with special insulation design to prevent heat loss, save energy, and comforts working environment.
4. Hydraulic system control at each station is separate. Every station can be operated individually to avoid idle waste. Production is more consistent and efficient.
5. Control of mold sliding device is separate, so the operation at the other side is not interfered and production is smooth.
 
Molds For Production
 
1. Traditional hot-compressed rubber molds can be utilized on the machine.
2. Clamping system is with direct hydraulic press; molds with different height can be adopted directly.
3. Automatic sliding devices for mold opening/closing is equipped to avoid mold damage caused by collision and to minimize cost of manpower.
 
Operation Design
 
1. One operator can handle multi stations to save labor cost.
2. Auto sliding devices at moving mold plates make operation easy; even female workers can operate the machine.
3. Auto inter-lock protection system for two-side simultaneous working assures safety of operation.
4. Mold change is simple and fast just by fixing bottom mold plate at sliding seat.
5. Every station is with independent operating control. Each station can be switched on/off according to production or maintenance schedules, in the meantime, to save power consumption.
 
Sliding Device
 
1. Auto sliding and inside turning at mold plates after mold opening ensures easy collection of product as well as saving manpower and eliminating labor injuries. 。
 
Electronic Control Unit
 
1. During operation, the supervisory control works continuously and assures proper functioning of “Diagnostic and Maintenance” procedure.
2. Memory of work files is provided. All parameter for each set of mold can be saved in work files to keep high efficiency on production.
 
Automatic Lifting Device For Mid-Mold Plate (OnlyTK-330-L Series)
 
1. To look for automation on production and save cost of manpower, TK-330-L model with automatic lifting device for mid-mold plate is available.
 

 

Item 
Unit 
330-3SL1
330-3SLV1
330E-3SL
330E-3SLV
Number of stations
No.
3
3
3
3
Clamping force
Tons
150
150
150
150
Mould-holder dimensions
mm
500×500
500×500
450×450
450×450
Mould height
mm
0~200
0~180
0~200
0~200
Open mould range
mm
250
230
250
250
Machine dimension(LxWxH)
m
3.6×4.7×2.6
4.7×3.9x2.6
3.75×5.1×2.55
3.8×5.1×2.6
Weight(Approximate)
Tons
14.3
14.3
13
13
Note:Above data only for reference.
levitra without prescription